Honeywell Focus Non

How do I connect my thermostat to the Internet? How do I register my thermostat for remote access? Once your thermostat is connected to the Internet you can register it by going to http: For warranty registration visit our warranty registration page. Why does the system need my home address? Your Carrier dealer can offer installation of an optional Wi-Fi router for your system. Remote Access How do I access my thermostat remotely?

RV Digital Thermostat Upgrade

You might need a small flat head screwdriver, depending on how your old thermostat is connected. This might also be the perfect time for me to inform you that by doing this project yourself, you assume all risks associated with it. Different wires from the thermostat control the different functions heat, cool, fan of your HVAC. The most common wires are: This switches on the gas, oil, or electric heat.

The thermostat installed in less than five minutes. Just remember to use the little color code stickers (my yellow wire was actually blue). I had already programmed the thermostat while sitting down – it does not need to be on the wall to program, and the actual deed took about 1 minute.

As water heaters age, they become less energy efficient and the tanks inside them corrode. This corrosion can cause leaks, and in some cases, cause the tank to burst, flooding your home. Installing a new water heater in time can prevent this from happening. The installation process for an electric hot water heater involves basic plumbing and electric skills. If you get a reading, go to the main electrical panel and turn off the correct circuit.

This circuit should have been turned off before you removed the old water heater, but double-checking the volt line that powers the water heater can save your life. Have an assistant help you move the water heater if you’re struggling to do it yourself. Place shims under the water heater to level it out, if needed. The Teflon tape helps provide a tight seal and prevents leaks from occurring. Use the red PEX tubing to connect the hot water outlet pipe on top of the water heater to the line that carries hot water to the faucets in your home, and the blue PEX tubing to connect the cold water inlet pipe on top of the water heater to the line that carries water into the water heater.

Open all of the hot water taps in your home. Allow the water to fill the tank, then flow out through the hot water line and through the spigots in your home. Allow the water to flow through the spigots for about a minute to bleed air that’s trapped inside the lines, and turn off the taps. Pull out the wires that are in the tank.

Desert Home: Super Thermostat

What you will learn in Thermostat Wiring Colors Code article: What thermostat wire color is likely to go to which terminal on the thermostat. Basic electrical safety and standards for wiring color The function of each wire terminal on the average thermostat. Additionally highlighting some of the differences in those functions from manufacturer to manufacturer. Wire is available here. Always turn the power off!

For a standard, 2,square-foot home, the cost of installing or replacing a thermostat averages between $ and $, including the price of the unit and professional national average cost is $The thermostat will run between $15 and $, depending on the type and its features.A licensed electrician can typically set one up in fewer than two hours at a rate of $65 – $

Below we will describe to you how to hook up a digital thermostat, hook up a programmable thermostat, or hook up any type for that matter. Whether the old thermostat is bad or not if you simply want to replace your old one and hook up a new one the first thing you need to take into consideration is to select the right replacement thermostat. To select the correct replacement you need to know what kind of HVAC equipment you have in your home or where you want to hook up the new thermostat.

There are numerous types of air conditioner and heating combinations so in this article, we will cover a basic gas furnace and air conditioner split system HVAC system. Thermostat Wiring Colors Code – Learn More about the Thermostat Installation opens in a new window How to Hook Up a Home Thermostat If you do not know what kind of unit you have to take a look at the paperwork from the last time the unit was serviced.

Perhaps it will show the type of equipment on the service ticket where the unit had maintenance. It is assumed that most people will know what kind of unit they have so that they can select the proper thermostat. It is best to place the thermostat in the same location as the old thermostat. Moving the thermostat to a new location is not recommended unless you hire an HVAC professional to relocate the thermostat first.

Thermostats need to be located in a strategic area of the home to be effective and work properly. Besides, you would have to pull new thermostat wire through the wall to relocate the thermostat and that is a big job for anyone.

Alexa, Turn Up the Heat!

When I took the front off the current honeywell thermostat, it looks like there are quite a few more wires than what the new thermostat will accept. Do I need a different thermostat? Your current thermostat is designed to allow independent control of the outside heat pump and the inside auxiliary furnace two stage on the heat side.

I installed a new two wire thermostat yesterday to an existing bedroom base board heater was working (got hot), but the old thermostat was not controlling the heat. Now the heater is barely throwing any heat, even though is turned way up.

Excellent product Average rating: After 12 years of dealing with constantly having to turn the dial down and up to get the correct temperature, I finally decided to upgrade to a digital thermostat. When I went to install the unit my wires didn’t match with the directions. The wires coming out of the wall had two white wires and one of the white wires was hooked up to where a yellow wire should have been, If your wires coming out of the wall are not the proper colors, I drew a diagram of the old system showing how the wires were hooked up on the old thermostat and I took close up pictures just in case.

Since one of the two white wires was being used as a yellow wire, I assumed it should be hooked up that way on the new one. I called customer service on a Saturday, and provided the female all of the old thermostat information and she looked it up in the computer and confirmed that I should continue to use the white wire as a yellow wire. The little paper labels they give you to mark the wires is a great idea, but they kept falling off, so I used color markers to mark the wires.

How to Hook Up Two Baseboard Heaters to One Thermostat

Super Thermostat I have two heat pumps to heat and cool my house. The house layout is such that there is no path from one part of the house to another for a big old air duct and two of them offer redundancy in case of failure. I have really nice programmable thermostats on the systems that can shut them off during the peak period but there are still a few things that would be nice to have.

Ability for each of them to know when the other one is on to prevent both of them from coming on at the same time, or restrict each thermostat to a specific period of time so they don’t overlap each other.

New Mexico Community Development Loan Fund, Albuquerque, NM, $1,, I was recently denied credit because of derogatory statement on my credit report(s). Loans may be provided only for the benefit of eligible small or rural health facilities.

Don’t be a pest to the forum. This website exists for fun and discussion only. The reader is responsible for discerning the validity, factuality or implications of information posted here, be it fictional or based on real events. The content of posts on this site, including but not limited to links to other web sites, are the expressed opinion of the original poster and are in no way representative of or endorsed by the owners or administration of this website.

The posts on this website are the opinion of the specific author and are not statements of advice, opinion, or factual information on behalf of the owner or administration of LunaticOutPost. The owners or administration of this website can’t be hold responsible for content hosted on sites that posters link to in; including, but not limited to, posts, signatures, private messages and such. This site may contain content not suitable for minors and if you feel you might be offended by such content, you should log off immediately.

This site may contain copyrighted material the use of which has not always been specifically authorized by the copyright owner. We believe this constitutes a ‘fair use’ of any such copyrighted material. The material on this site is distributed without profit to those who have expressed a prior interest in receiving the included information for research and educational purposes.

Desert Home: Super Thermostat

I really appreciate your info and it gives me a lot of ideas. One problem with any manual thermostat solution that’s not automatic is this: I could trivially put another switch breaking the thermostat line on the wall near the door, but it’s not exactly what I need. The scenario that I’m trying to avoid is that my wife has a garage control on her key-chain and has accidentally hit it a couple of times in her pocket or purse.

Reader question: I just picked up a new Trane programmable thermostat for our air conditioner/heat pump system. When I took the front off the current honeywell thermostat, it looks like there are quite a few more wires than what the new thermostat will accept.

I like to make a cup of drip coffee in the morning, and although the coffee pot didn’t require a pure sine wave inverter, some things do, so that was my choice. Rather than adding a transfer switch, I added a dedicated outlet on the side of the sink. The remote is located in the front of the sink cabinet. While the ProWatt inverter remote will shut off the inverter completely, I added a heavy duty amp switch since I prefer to have a way other than the fuse to disconnect the input wiring to the inverter.

I also moved the trailer disconnect switch forward so that it is easier to reach when the dinette is made into a bed something I have pretty much done permanently. The next additions are some fancy hooks.

Fixed My House Thermostat

Over the past 6 months or so I’ve noticed a drop in highway mpg from to approx After checking out a number of forum discussions particularly bimmerfest and some European d forums , I thought possibly my thermostat was malfunctioning, with resultant low engine temps. So a low engine temperature for the diesels may cause poor mpg, burn out of glow plugs, and DPF malfunction.

This link on bimmerfest gives an excellent overview of the issue. As said by lpcapital in post 5:

Let your contractor hook up the new wire to the furnace and turn on the furnace’s power. Now snap the thermostat’s face onto the bracket. When it lights up, follow the prompts to set the temperatures you want the house to be when you wake up, leave for work, return home, and go to bed.

The Bellmen lobbied unsuccessfully to keep said hot tub. Taking down these walls allowed the extremely-frigid Canadian winter air to bombard exposed pipes. The pipes burst shocker! I awoke Monday morning to a call from work. Ceiling tiles hung precariously. Office computers buzzed as they shorted out. There was an eerie silence.

Cue the horror movie score. Even though the upper floors were unaffected I spent the next several hours evacuating guests. We drafted other staff members to act as temporary bellmen, though none of them rose to my level of snark. The hotel was devoid of guests and the water had been sucked up and pushed out the front doors seriously!

The truth is, travelers are cheaper and more hostile than ever.

Thermostat wiring color code decoded